### WiFi network settings in Extended.config.h

Source: https://groups.io/g/onstep/wiki/Smart-Hand-Controller

Optional settings for OnStepX; defaults work unless changed. Configure host name, SSID, password, and IP address.

```cpp
#define ONSTEP1_HOST_NAME "OnStep"
#define ONSTEP1_SSID "ONSTEP"
#define ONSTEP1_PASSWORD "password"
#define ONSTEP1_IP_ADDR {192,168,0,1}
```

--------------------------------

### Language configuration (English)

Source: https://groups.io/g/onstep/wiki/Smart-Hand-Controller

Set the display language to English (Metric). Other languages can be added with translation.

```cpp
#define DISPLAY_LANGUAGE L_en
```

--------------------------------

### WiFi serial configuration in Config.h

Source: https://groups.io/g/onstep/wiki/Smart-Hand-Controller

Required in Config.h when using WiFi.

```cpp
#define SERIAL_ONSTEP SERIAL_IP
```

--------------------------------

### WiFi station mode in Extended.config.h

Source: https://groups.io/g/onstep/wiki/Smart-Hand-Controller

Required in Extended.config.h when using WiFi.

```cpp
#define SERIAL_IP_MODE STATION
```

--------------------------------

### Display configuration for 1.54" SSD1309 OLED

Source: https://groups.io/g/onstep/wiki/Smart-Hand-Controller

Set this in SmartHandController's Config.h to use a 1.54" OLED display (SSD1309).

```cpp
#define DISPLAY_OLED SSD1309
```

--------------------------------

### Display configuration for 1.3" SH1106 OLED

Source: https://groups.io/g/onstep/wiki/Smart-Hand-Controller

Alternative display setting for a 1.3" OLED using the SH1106 driver.

```cpp
#define DISPLAY_OLED SH1106
```

--------------------------------

### Display configuration for 1.3" SSD1306 OLED

Source: https://groups.io/g/onstep/wiki/Smart-Hand-Controller

Alternative display setting for a 1.3" OLED using the SSD1306 driver.

```cpp
#define DISPLAY_OLED SSD1306
```

=== COMPLETE CONTENT === This response contains all available snippets from this library. No additional content exists. Do not make further requests.